E36 Rear Subframe/Chassis Reinforcement Kit

A must for E36 track, autocross or dual-duty cars - factory fit and easy to weld in

+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -



Our E36 Rear Subframe/Chassis Reinforcement kit is an absolute must for any E36 that sees track or autocross use, and with the age and mileage of most E36 chassis, it’s a good idea for high-performance street cars, too. 

Most 1995+ E36 M3s have reinforcement plates welded in from the factory, but BMW didn’t see fit to add these much-needed structural supports to Non-M E36s. The area where the rear subframe attaches to the chassis is a well-documented failure point, especially on heavily-tracked E36s. If you track or plan to track your Non-M E36, it’s not a matter of if but when you’ll need to repair this area - it’s much easier and safer to plan this out as preventative maintenance than to wait for the inevitable.

The reinforcement plates in our E36 Rear Subframe/Chassis Reinforcement Kit are a factory fit and can be installed easily when subframe bushings are added. NOTE: Welding is required.

  • Weld-in reinforcement kit
  • Highly recommended for any E36 used on track/autocross
  • Factory fit - same quality as factory reinforcements on the E36 M3
  • Easy to install when replacing subframe bushings
These reinforcements were added to E36 M3s midway through the 1995 model year but there is no exact month. It's possible that early 1994 production models did not receive them. However, all 1996-1999 M3s had them from the factory.

BMW Fitments:
3 Series
E36 (92-99) > 318i M42
E36 (92-99) > 318i M44
E36 (92-99) > 318ic M42
E36 (92-99) > 318ic M44
E36 (92-99) > 318is M42
E36 (92-99) > 318is M44
E36 (92-99) > 323ic
E36 (92-99) > 323is
E36 (92-99) > 325i
E36 (92-99) > 325ic
E36 (92-99) > 325is
E36 (92-99) > 328i
E36 (92-99) > 328ic
E36 (92-99) > 328is
E36 (92-99) > M3 (early 1995)
Recently Viewed Products