Brake Wear Sensors are key safety components that allow worry-free driving without the need for constant visual inspection of your brake pad material. Once the brake lining dash light is illuminated on your dash, this is a warning of thin brake pad material. Pads should be replaced as soon as possible, and the sensor is a required replacement once the brake lining dash has come on.
- Precise factory fitment
- Worry-free driving until dash light illuminates
- One sensor required per axle (except E9X M3 which has 2 fronts and 1 rear)
Priced per REAR brake wear sensor.
TECH NOTE: On a majority of applications the brake lining light can be reset easily by installing a new sensor and turning the ignition to the second position (without starting the car) for approximately one minute - or until the light goes out. Refer to your Bentley service manual for further instruction if this method doesn't work.
BMW Fitments: 1 SeriesE82 / E88 (08-13) > 128i
E82 / E88 (08-13) > 135i
E82 / E88 (08-13) > 135is
E82 / E88 (08-13) > 1M (11-12)
3 SeriesE90 / E91 / E92 / E93 (06-13) > 323i
E90 / E91 / E92 / E93 (06-13) > 325i
E90 / E91 / E92 / E93 (06-13) > 325xi
E90 / E91 / E92 / E93 (06-13) > 328i
E90 / E91 / E92 / E93 (06-13) > 328xi
E90 / E91 / E92 / E93 (06-13) > 330i
E90 / E91 / E92 / E93 (06-13) > 330xi
E90 / E91 / E92 / E93 (06-13) > 335d
E90 / E91 / E92 / E93 (06-13) > 335i
E90 / E91 / E92 / E93 (06-13) > 335is
E90 / E91 / E92 / E93 (06-13) > 335xi
E90 / E91 / E92 / E93 (06-13) > M3
