This is a set of upper and lower rod bearings with the WPC surface treatment for E60 M5 and E63 M6 with the S85 V10 engine.
We take a standard BMW bearing shell and give it the WPC treatment, a microscopic shot-peening of the bearing -
- Removes high spots and imperfections
- Improves fatigue resistance
- Increase the surface's oil retention abilities for more lubrication
- Safer than a coating and will not decrease clearances
- Preserves the factory bearing's metallurgy
Rod bearings are a typical wear item and critical on high revving engines like the S85. The WPC treatment will prolong bearing life and reduce friction, however, bearings are still a wear item. There is no official replacement interval from BMW but we have seen and heard of high bearing wear as soon as 60,000 miles. We feel comfortable recommending a preventative replacement at 80,000 miles from stock bearings and expect a longer interval for treated bearings (data for this is still pending). Track your bearing wear with regular used oil analysis and plan on rod bearing replacement some time in your engine's future.
Bearings are sold by size. These are the standard 53.0mm inside diameter size.
Note: connecting rod bolts cannot be re-used. They are stretch-to-yield and must be replaced.
Price is for the set of 20 bearings for the V10.
Engine Oil Note: we strongly recommend a quality oil such as Red Line because of its higher zinc content and better protection values at operating temps. For a dedicated track/race car the Red Line Racing oil has the most zinc and shear strength (but lacks the detergents desirable in street oils). Correct oil operating temperature is 220°F - you should properly warm your engine before subjecting it to higher throttle angles and RPM. For more info on engine oil in general, check out our Oil Tech Page by clicking here.
E60 M5 (2006, 2007, 2008, 2009, 2010) > M5
E63 / E64 M6 (2006, 2007, 2008, 2009, 2010) > M6 coupe & M6 convertible