The Epic Motorsports E36 M3 Sport Camshaft set was created using state of the art design and engineering processes, resulting in a superior product that is suitable for both street and race engines alike. The high-lift profile opens the door to new levels of power – 15 Hp more than any other cam we have tested. This design very closely matches the Sunbelt E36 M3 cams which are no longer available.
Epic's carefully tuned lobe profile allows safe operation at revs over 7,400 RPM with stock valve train with a noticeable gain in high-end horsepower, allowing you to truly take advantage of this new RPM territory without sacrificing low-end torque. Note: We recommend 3.2L engines use alternate lightweight bottom-end components.
Cams are sold in pairs only and fit U.S.-spec 3.0L and 3.2L M50-based E36 M3/Z3 engines (1995-1999 M3, 1996-2000 Z3).
Epic Motorsports Spring Kit is recommended but not required.
Valve Timing Information
Intake
Exhaust
Valve Lash
Hydraulic
Hydraulic
Valve Lift
.421" (10.7mm)
.418"
Duration
259°
249°
Duration @ 0.050
236°
226°
Notice of Emissions Non-Compliance. This product is intended only for vehicles that may never be used, or registered or licensed for use, upon a public highway. Removing, disabling, or altering emissions equipment on a pollution-controlled road vehicle is illegal. Installing devices or software that trick, disable, or modify emissions controls and monitors on a pollution-controlled road vehicle is also illegal. This product is sold only for racing, competition, track, hobby, or other off-road use. It is not legal for installation or use in California on any pollution controlled motor vehicle. It is not legal for installation or use on any pollution controlled motor vehicle in any state, province, or jurisdiction governed by, or which has adopted, CARB or EPA regulations. Some suppliers have shipping exceptions to certain states or territories, requiring extra delivery time. We will advise you of any delays.
