Injen Hot-Side Chargepipes - F8X M2/M3/M4
Stronger piping, better flow, less turbo lag
These Injen Charge Pipes for the F87 M2 Competition, F80 M3, and F82/F83 M4 are smoother flowing than the stock, compressed plastic pipes. These pipes replace the hot-side pipes leaving the turbos and into the top-mount intercooler. These high-grade 6061-T1 aluminum pipes are mandrel bent for better flow, which helps reduce turbo lag and improve throttle response. The CNC-machined flanges have beaded ends to prevent the pipes from slipping off under high boost. All of the factory mounting points are retained for a direct replacement for the stock S55 chargepipes.
Offered with either black or red wrinkle finish with the Injen logo and silicone couplers to the stock or most aftermarket top-mount intercoolers (including CSF).
For bulletproof turbo piping and higher flow, Injen intake components are the total solution.
Notice of Emissions Non-Compliance. The intake component is part of a vehicle's emissions equipment. Removing, disabling, or altering emissions equipment on a pollution-controlled road vehicle is illegal. Installing devices or software that trick, disable, or modify emissions controls and monitors on a pollution-controlled road vehicle is also illegal. Unless noted above, this product is not legal for installation or use in California on any pollution controlled motor vehicle. Not legal for installation or use on any pollution controlled motor vehicle in any state, province, or jurisdiction governed by, or which has adopted, CARB or EPA regulations.
F87 (2019+) > M2 Competition
F80 (2015+) > M3 (2015+)
F82 / F83 (2015+) > M4 (2015+)