Schrick 284-deg Camshaft - E30 M3 (S14 )

Sport cam for mid-high RPM power gains and minimal loss of torque

+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -

  •  

Price:
$541.99

Schrick 284° performance camshaft for the S14 engine used in the E30 M3. This would be used on the intake side for a street-driven M3 (usually paired with the 276 exhaust cam).

Camshaft tuning is all about optimizing air/fuel flow for your specific needs. The higher degree will open the valves sooner, deeper into the combustion chamber, and for longer time. Choosing the correct camshaft depends on the rest of your engine specs and goals. More aggressive cams should be paired with appropriate air and fuel upgrades to make full use of their operating specs.

Schrick does not require any additional hardware with this cam but they do recommend new valve springs, seats, and retainers. Contact us for a package price. The BMW Motorsport/Evo 3 valve springs are also a common recommendation.

All Schrick camshafts are made in Germany using wear-resistant chilled cast iron and machined with advanced CNC equipment. They have a one year warranty.

S14 284 cam specs:
Lobe Duration: 284°
Valve Lift: 11.5mm
Valve Lift @ TDC: 3.5mm
Valve Timing (IO-IC-EO-EC): 36-68 68-36
Intake Valve Clearance: 0.25mm (0.0098")
Exhaust Valve Clearance: 0.30mm (0.012")

Manufacturer's Notes:
1. While new springs may not be required, you must ensure the new valve lift does not fully compress the spring. It may be necessary to shim the spring's installed height.
2. Valve timing and valve opening durations are shown minus the ramps.
3. Valve timing is shown in °Crankshaft in relation to TDC.
4. All valve lift figures are shown without deduction of valve lash, i.e. the actual valve lift is the stated valve lift minus the valve lash. Hydraulic lifters have no lash so the valve lift is the actual valve lift.
5. Lumpy or rough idle is caused by valve overlap (intake and exhaust valves open at the same time). Some of the lumpy idle can be adjusted out with a proper valve adjustment using the new specs. Some roughness may remain, depending on the aggressiveness of the cam.

Notice of Emissions Non-Compliance. This product is intended only for vehicles that may never be used, or registered or licensed for use, upon a public highway. This cam is designed to be used with all original, factory-installed equipment, including emissions controls. Removing, disabling, or altering emissions equipment on a pollution-controlled road vehicle is illegal. Installing devices or software that trick, disable, or modify emissions controls and monitors on a pollution-controlled road vehicle is also illegal. This product is sold only for racing, competition, track, hobby, or other off-road use. It is not legal for installation or use in California on any pollution controlled motor vehicle. It is not legal for installation or use on any pollution controlled motor vehicle in any state, province, or jurisdiction governed by, or which has adopted, CARB or EPA regulations.

BMW Fitments:

3 Series
E30 (84-91) > M3
Recently Viewed Products