BimmerWorld Full Race Exhaust By Magnaflow - E46 323i/325i/328i/330i (Header-Back) (Spec E46)

BimmerWorld Full Race Exhaust By Magnaflow - E46 323i/325i/328i/330i (Complete System)

+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -



Our lightweight, high-quality stainless exhaust system sets the standard for maximizing power from your E46 6-cylinder non-M track machine. Easy bolt-on installation. This is the required exhaust for all cars running in Spec E46. Kit includes Y-Pipe required for integration into E36 OBDII headers.

Our BimmerWorld E46 Exhaust System by MagnaFlow is the only choice when you want the most power out of your Non-M E46 track or race car. The stock twin-pipe (or even single in some models) configuration simply doesn't cut it. We see a lot of cars that have transitioned from street to dedicated track use, and while they have nice aftermarket rear mufflers and even center sections without cats, those lighter-than-stock systems may be nice for street cars, but the design limits the power and performance of your car. Great street performance parts don't always make great race parts, and we can often do much better with a dedicated track design.

The BimmerWorld E46 Non-M Race Exhaust System by MagnaFlow is made of thinner-walled stainless 3" single pipe to significantly reduce weight, even when compared to stainless aftermarket street parts. The 3" configuration also serves to maximize horsepower output as accelerating in traffic won't be a concern when you're wringing the engine out at the racetrack.

This exhaust system includes both a mid-section resonator and straight pipe option, allowing you to reduce or increase volume as needed to meet sound limits. With the resonator installed, volume will typically be acceptable for more highly-restricted tracks such as Laguna Seca and Lime Rock, but environmental conditions and results may vary. V-band clamps are used throughout the system to make swapping out pieces or dropping the exhaust for maintenance or trackside repairs fast and easy - once installed, this exhaust can come off for typical work in minutes.

Included Y-pipe bolts directly to your self-supplied stock E36 exhaust manifolds, which remove the catalytic converter from your car without cutting and welding of your stock E46 parts. One O2 port is included for running a wideband sensor for data. The original post-cat O2 sensors can be removed, per Spec E46 rules and software tune. Our Y-pipe uses a proper racing merge collector, with primary legs designed in combination with factory E36 exhaust manifolds to simulate an equal-length header, which times exhaust pulses for improved scavenging and increased power.

Installation uses factory mounting points with necessary hardware included. This system was designed for the ZF 5-speed transmission, which is the most common in SE46. For this to work with the 6-speed you need to use the AAF transmission brace or the merge collector will need to be clearanced away from the factory transmission brace and the wideband O2 bung will be inaccessible.

E36 exhaust manifolds required and not included.

Made in USA

Notice of Emissions Non-Compliance. This product is intended only for racing vehicles that may never be used, or registered or licensed for use, upon a public highway. Removing, disabling, or altering emissions equipment on a pollution-controlled road vehicle is illegal. Installing devices or software that trick, disable, or modify emissions controls and monitors on a pollution-controlled road vehicle is also illegal. This product is sold only for racing, competition, track, hobby, or other off-road use. It's use is prohibited in any motor vehicle that is subject to emissions inspection or control. It is not legal for installation or use on any pollution controlled motor vehicle in any state, province, or jurisdiction governed by, or which has adopted, CARB or EPA regulations. BimmerWorld may confirm a customer's racing license, entry, track participation, and we may ask for photos or proof of a permanent race car build. We reserve the right to cancel part(s) that are not for legitimate racing or track purposes. Some suppliers have shipping exceptions to certain states or territories, requiring extra delivery time. We will advise you of any delays.

BMW Fitments:

3 Series

E46 (99-00) > 323i
E46 (01-05) > 325i
E46 (01-06) > 325ci
E46 (99-00) > 328i
E46 (01-05) > 330i
E46 (01-06) > 330ci
Recently Viewed Products