BimmerWorld Racing E9X M3 X-Pipe -
- Over 30hp gain with no other mods!
- Optimized design and layout - X-Pipe design, placement, and dimensions/sizing based on stock headers and flow
- Mandrel-bent 2.5" tubing - tubes are assembled and bent with minimum of connections for smoother exhaust gas flow and long-term durability
- Fitment with stock headers and any axle-back muffler
- Full 304 stainless steel construction for heat retention, durability, and corrosion resistance.
- 27lbs total - huge weight savings over stock!
There are a lot of E90 M3 / E92 M3 test pipes, center pipes, mid-sections on the market but this has to be the best one. Test Pipes require you to cut your stock exhaust and still leaves secondary catalytic converters. Other mid-pipes or center sections don't have an x-pipe or have it placed too far away to have much benefit. After a lot of R&D and testing, including racing with multiple designs, we now have the E9X M3 center pipes to trump them all.
The key to our center section is the X-pipe placed as far forward as possible. An X-Pipe has been proven to increase torque and horsepower, especially in the upper RPM ranges. The X-Pipe design relies on exhaust velocity to be the most effective so it must be located as close to the engine as possible. Our location is right where both banks merge, an ideal location. The front half of our exhaust works just like any Test Pipe set on the market, eliminating the primary cats. The rear half of our system eliminates the secondary cats and is also optionally available with straight pipes
for maximum flow or with resonators to tone down the exhaust note (See BimmerWorld part # 1004329 for the straight pipe "Race" version
). Made in the USA from 304 stainless steel.
Epic Motorsports tuning is very strongly recommended with this exhaust. Exhaust flow is significantly changed with this design and special tuning may be desired to restore low-end torque and take full advantage of the increased flow. Other tuning software - even Race tunes - may not take this change into account.
These are designed for race or track use only. They bolt to the stock S65 headers with factory gaskets and any rear exhaust muffler system can be used. This allows you to remove and store your stock catalytic converter/mid-section without having to cut it up. If you need to go back to stock in the future, simply swap center sections and continue.Notice of Emissions Non-Compliance.
This product is intended only for racing vehicles that may never be used, or registered or licensed for use, upon a public highway. Removing, disabling, or altering emissions equipment on a pollution-controlled road vehicle is illegal. Installing devices or software that trick, disable, or modify emissions controls and monitors on a pollution-controlled road vehicle is also illegal. This product is sold only for racing, competition, track, hobby, or other off-road use. It's use is prohibited in any motor vehicle that is subject to emissions inspection or control. It is not legal for installation or use on any pollution controlled motor vehicle in any state, province, or jurisdiction governed by, or which has adopted, CARB or EPA regulations. BimmerWorld may confirm a customer's racing license, entry, or track participation and reserves the right to cancel part(s) that are not for legitimate racing or track purposes. Some suppliers have shipping exceptions to certain states or territories, requiring extra delivery time. We will advise you of any delays.
BMW Fitments: 3 Series
E90 / E91 / E92 / E93 (06-13) > M3