OBD I Manifold Conversion Throttle Body Adapter

Required for proper OBD I manifold conversions on 96+ cars

+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -

  •  

Price:
$19.99

This OBD I Manifold Conversion Throttle Body Adaptor is required when the 92-95 M50 intake plenum is installed on a car using the 96+ style throttle body. 

This plates allows the two O-rings to make a proper seal for full air-leak protection. Laser cut from stainless steel, tumbled finish.

Notice of Emissions Non-Compliance. This product is intended only for racing vehicles that may never be used, or registered or licensed for use, upon a public highway. Removing, disabling, or altering emissions equipment on a pollution-controlled road vehicle is illegal. Installing devices or software that trick, disable, or modify emissions controls and monitors on a pollution-controlled road vehicle is also illegal. This product is sold only for racing, competition, track, hobby, or other off-road use. It's use is prohibited in any motor vehicle that is subject to emissions inspection or control. It is not legal for installation or use on any pollution controlled motor vehicle in any state, province, or jurisdiction governed by, or which has adopted, CARB or EPA regulations. BimmerWorld may confirm a customer's racing license, entry, track participation, and we may ask for photos or proof of a permanent race car build. We reserve the right to cancel part(s) that are not for legitimate racing or track purposes. Some suppliers have shipping exceptions to certain states or territories, requiring extra delivery time. We will advise you of any delays.

BMW Fitments:

3 Series
E36 (92-99) > 323ic
E36 (92-99) > 323is
E36 (92-99) > 328i
E36 (92-99) > 328ic
E36 (92-99) > 328is
E36 (92-99) > M3 (96-99)
Recently Viewed Products