Tools

Plastic jack point cover to replace worn or missing pads on your E36

Save hours of labor and hundreds of dollars! Convenient and affordable rental.

Save hours of labor and hundreds of dollars! Remove old and install Powerflex RTABs without removing the arms!

Required to align clutch disc during installation

Required to align clutch disc during installation

Required to align clutch disc during installation

Plastic jack point cover to replace worn or missing pads

The go-to choice for a one-person brake pressure bleeder on most BMWs

Robust tool that won't fall apart - perfect for filling transmission and differential fluid

Budget-minded tool for rear bushings or bearings

Cost-effective tool required to unlock, raise and lower MCS spring perches

Enhance the performance and longevity of OPTIMA AGM and traditional batteries 

Makes bushing replacement easy - for use with E30, E36, E46 and Z3/Z4

Adapt any Motive brake pressure bleeder to work on your European car

Replacement rod for our BimmerWorld E36/E46 Trailing Arm Bushing Tool.

Adapt any Motive brake pressure bleeder to work on most import cars

Factory jacking point for 3 Series Coupes 2007-2013

High quality, 24 Month Warranty

Premium quality Krontec 2-stage air jack stand

Required to align clutch disc during installation

Factory BMW tool to extract the front crankshaft seal. Genuine BMW part #83300496266.

Special extended-length T60 Torx socket for flywheel bolts.

Bleed your brakes without any mess!

Tie down your BMW with the factory-intended method for safe trailering

Genuine BMW trickle charger for all battery types

Adapter that is ideal for vintage BMWs and the pinch seam on the rocker panel

A requirement for proper and accurate race damper setup

Removes the oil filter cap from N20, N26, N51, N52, N54, N55, S55, N63, S63, and N73 engines.

Required to align clutch disc during installation

Required to align clutch disc during installation

Solid protection for the cylinder head intake and exhaust ports on M5X and S50/S52 engines.

Solid protection for the cylinder head intake and exhaust ports on S54 engine.

Set of 5 plastic pry tools for pushing and pulling wiring without damage to the wire insulation.

Set of 2 L-shaped plastic pry tools for leverage in hard-to-reach areas.

Set of 8 double-ended plastic prying and scraping tools.

Bridge to lock S54 cams in place

Double-ended metal pry tool for removal of body trim.

Mark fasteners after final tightening for a visual cue if they loosen or are tampered with.

This professional tool set makes installation of new detents much easier

Professional-quality press tool for removal and installation of xDrive transfer case mounts.