Tools

Small jaw for CTA-8070 puller tool. Sold individually.

1-inch wide scraping tool with a comfortable plastic handle.

Metal pry tool for maximum leverage on fasteners and trim parts.

2-piece pick set for removal of o-rings and oil seals.

Mark fasteners after final tightening for a visual cue if they loosen or are tampered with.

Removes the oil filter cap from N20, N26, N51, N52, N54, N55, S55, N63, S63, and N73 engines.

Plastic jack point cover to replace worn or missing pads on your E36

Remove interior trim and plastic fasteners without damaging surfaces.

Replaces BMW # 51717237195 and 51717123311

Required to align clutch disc during installation

Plastic jack point cover to replace worn or missing pads

Lock a hood shock or trunk shock open while performing service work. 

Threaded adapter for use with the CTA Tools pressurized brake bleeder tool.

Required to align clutch disc during installation

Required to align clutch disc during installation

Required to align clutch disc during installation

Required to align clutch disc during installation

Bleed your brakes without any mess!

Set of 2 L-shaped plastic pry tools for leverage in hard-to-reach areas.

Universal transmission filler adapter with 8-inch long hose.  Use with CTA 7400 ATF Filling System.

Transmission filler adapter for ZF automatic transmissions.

Easily remove wiper arms from the drive motor assembly.

Double-ended metal pry tool for removal of body trim.

Extended-length plastic pry tool for interior trim, body moldings, and plastic fasteners.

Temporarily close rubber brake/coolant/vacuum hoses without damaging them.

Set of 5 plastic pry tools for pushing and pulling wiring without damage to the wire insulation.

Replacement rod for our BimmerWorld E36/E46 Trailing Arm Bushing Tool.

Adapt any Motive brake pressure bleeder to work on your European car

Remove interior and exterior plastic fasteners and moldings with this set of pry tools.

Adapter that is ideal for vintage BMWs and the pinch seam on the rocker panel

Makes bushing replacement easy - for use with E30, E36, E46 and Z3/Z4

Budget-minded tool for rear bushings or bearings

Quickly and easily pushes the exhaust bracket out of the rubber isolator/hanger.

Factory jacking point for 3 Series Coupes 2007-2013

Set of 8 double-ended plastic prying and scraping tools.

Adapt any Motive brake pressure bleeder to work on most import cars

Designed for adjusting MCS spring perches and lock plates

Floor jack adapter to lift your newer BMW safely and securely

Upgraded and premium wheel pin tool that screws into the hub. Replaces BMW part #71111093774.

Factory wheel pin tool that slides into the hub. Genuine BMW part #71111093774.