This convenient package includes the essential parts for installing a pair of 2-piece 10mm hubcentric spacers with hub extenders (5x112mm / 66.56mm center bore) on G8X M2, M3, and M4 models. This kit includes ten (10) M14 75mm street wheel studs, sized correctly for a 10mm spacer. This is one pair of spacers, enough for one axle (two wheels) on either the front or rear of the car.
Our BimmerWorld 10mm Wheel Spacers are specifically designed to fit the segmented hubcentric lip on BMW G8X models - G87 M2, G80 M3, G82/G83 M4, including xDrive cars. A 10mm was a tricky fit on the hub but we solved it by designing the spacer and lip as two pieces - the 10mm flat spacer and a NEW hubcentric lip that fits with the existing lip and locks in place between the tabs on the hub. This new lip has a surface area equal to the original (within 0.5mm) so there won't be any interference or loss of surface area for your existing wheels.
Video: BimmerWorld BMW 5x112 Wheel Spacer Test Fit
Package Includes:
2 x 10mm black anodized 2-piece spacers (5x112 / 66.56mm CB)
10x 75mm street wheel studs (M14 x 1.25)
Threadlocker capsule
2x M14 install nuts
Printed instruction sheet
Wheel Spacer Features:
2-piece design with tight tolerances
Hub Extender that engages with the tabs on the hub
Precision-machined lightweight design
100% 6061-T6 aluminum alloy
Hard anodized for corrosion resistance
Ledge around inner rim for prying off stuck spacers
Machined pocket on inner bearing surface to reduce spacer sticking
Extra large holes to accommodate 14mm bolts or studs
Note 1: This hub extender only fits on a hub with tabs/prongs/teeth/fingers/cutouts. It will not fit on a hub that has a full surface lip around the circumference.
Note 2: Hub, spacer, and wheel must fit together with zero gap between them. A gap between any component is a cause for failure. Check for a snug fitment with no wobble on each component. Click this link to learn more and watch a video of our paper test to ensure a proper and safe fitment.
Note 3: These 10mm spacers must only be used with the included hub extenders. Never use the flat spacer on its own.
Our BimmerWorld Wheel Spacer Set (with wheel studs) is specifically designed to fit your BMW's 66.56 mm hub, retaining the proper hub centric design while adding highly desired track width. They're designed to work with factory BMW wheels and nearly all aftermarket wheels. Whether you need a spacer set for correct wheel fitment, clearance for a set of big brake calipers or if you just want to widen your track width, we have the correct spacer to fit your needs.
Need help with wheel spacers or wheel bolts and hardware? Please contact us and let one of our wheel experts assist you.
“What is the BMW wheel nut torque?” Our torque spec for M14 wheel nuts (not bolts) is 90ft-lbs done when the nuts and wheel are cold (ambient temp). Do not torque when the nuts are hot and do not exceed 90ft-lbs. Remember that nuts - and studs - are consumables and should be inspected and replaced periodically. See our instructions link above for complete stud and nut installation guidelines.
