This pair of 11mm H&R wheel spacers are designed for use on BMW models with a 5x132mm bolt pattern and 66.5mm wheel center bore. This is the new BMW wheel spec that all G90/G99 M5 models use. Choose from black or silver hard-anodized finish.
An 11mm spacer is a special fitment on BMW G-chassis models. The stock lip may stick out further than the width of the spacer, causing the spacer to not seat all the way to the hub. You must check the existing depth of the stock lip and confirm it is less than 11mm before installing these spacers. Do not install these spacers if the lip depth exceeds 11mm. Also, the bevel on the backside of the wheel must be 90° or more. Less than 90° will not leave enough of the wheel to contact the lip.
- Longer wheel bolts are absolutely required with these spacers, unless wheel studs are used. Please see below for BimmerWorld recommended related items.
- Please measure your wheel gap before ordering spacers. Wheel spacers ARE NOT RETURNABLE if packaging is opened.
- Thoroughly clean the hub surface and brake rotor hat before mounting. Rust and other debris may interfere with spacer fitment. The spacer must be fully seated against the brake rotor hat (not bottomed-out on the lip).
- Ensure that your bolts are fully engaged before use - M14x1.25 wheel bolts require 9.0 turns or 14mm of engagement to be considered fully tight.
- Do not use anti-seize on bolt threads and torque bolts to 88ft-lbs. Spin wheel to ensure longer wheel bolts do not interfere with hub internals.
BMW Fitments:
5 Series
G90/G99 (2025+) > G90/G99 M5
