Brake Wear Sensors are key safety components that allow worry-free driving without the need for constant visual inspection of your brake pad material. Once the brake lining dash light is illuminated on your dash, this is a warning of thin brake pad material. Pads should be replaced as soon as possible, and the sensor is a required replacement once the brake lining dash has come on.
- Precise factory fitment
- Worry-free driving until dash light illuminates
- One sensor required per axle
Priced per REAR brake wear sensor.
TECH NOTE: On a majority of applications the brake lining light can be reset easily by installing a new sensor and turning the ignition to the second position (without starting the car) for approximately one minute - or until the light goes out. Refer to your Bentley service manual for further instruction if this method doesn't work.
BMW Fitments:
3 Series
E36 (92-99) > 318i M42
E36 (92-99) > 318i M44
E36 (92-99) > 318ic M42
E36 (92-99) > 318ic M44
E36 (92-99) > 318is M42
E36 (92-99) > 318is M44
E36 (92-99) > 323ic
E36 (92-99) > 323is
E36 (92-99) > 325i
E36 (92-99) > 325ic
E36 (92-99) > 325is
E36 (92-99) > 328i
E36 (92-99) > 328ic
E36 (92-99) > 328is
E36 (92-99) > M3 (1995)
E36 (92-99) > M3 (96-99)