BimmerWorld E36 Race Exhaust by MagnaFlow

Lightweight full 3" stainless steel exhaust system for maximum power. Only 24 lbs! 

+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -

  •  

Price:
$1,049.99

This lightweight, high-quality stainless system sets the standard for maximizing power from your E36 6-cylinder track machine. Our front Y-Pipe works in concert with your stock manifolds to simulate an equal-length system resulting in noticeable power gains versus typical performance exhausts we've tested.

When you want the most power out of your E36, the stock twin-pipe configuration simply doesn't cut it. We see a lot of cars that have transitioned from street to track use with nice aftermarket rear mufflers and even non-catted center sections. Yet while lighter than stock and better in a streetcar sense, this layout limits the power and performance of your car. Great street performance parts don't always make great race parts, and we can often do much better with a dedicated track design.

Now we have the BimmerWorld E36 Race Exhaust System. Made of thinner walled stainless tubing in a single 3" pipe design, weight is significantly reduced, even versus stainless aftermarket street parts. The 3" configuration also serves to maximize horsepower output as accelerating in traffic won't be a concern when you're wringing out the engine at the racetrack.

This System includes both a mid-section resonator and straight pipe, to reduce or increase volume as needed to meet sound limits or personal preference. V-band clamps are used throughout to make swapping out pieces or dropping the exhaust for maintenance or trackside repairs fast and easy - once installed, this exhaust can come off for typical work in minutes.

This exhaust weighs in at only 28 lbs with the resonator -- and only 24 lbs with the straight pipe! (Wow!) This is a substantial weight savings over stock as well as the typical stainless exhausts on the market.

This system connects with either our BimmerWorld Front Y-pipe or the Active Autowerkes long tube headers (or your own custom option. The Front Y-Pipe uses a proper racing merge collector, and primary legs that are designed to time exhaust gas pulses like a long-tube equal-length header when combined with factory exhaust manifolds.

Installation uses factory mounting points with the necessary hardware included. Fits all 6-cylinder E36 models, except 318ti chassis.

Made in USA.

Required for Install: BimmerWorld Front Y-pipe or AA Header


Notice of Emissions Non-Compliance. This product is intended only for racing vehicles that may never be used, or registered or licensed for use, upon a public highway. Removing, disabling, or altering emissions equipment on a pollution-controlled road vehicle is illegal. Installing devices or software that trick, disable, or modify emissions controls and monitors on a pollution-controlled road vehicle is also illegal. This product is sold only for racing, competition, track, hobby, or other off-road use. It's use is prohibited in any motor vehicle that is subject to emissions inspection or control. It is not legal for installation or use on any pollution controlled motor vehicle in any state, province, or jurisdiction governed by, or which has adopted, CARB or EPA regulations. BimmerWorld may confirm a customer's racing license, entry, or track participation and reserves the right to cancel part(s) that are not for legitimate racing or track purposes. Some suppliers have shipping exceptions to certain states or territories, requiring extra delivery time. We will advise you of any delays.

BMW Fitments:

3 Series
E36 (92-99) > 323ic
E36 (92-99) > 323is
E36 (92-99) > 325i
E36 (92-99) > 325ic
E36 (92-99) > 325is
E36 (92-99) > 328i
E36 (92-99) > 328ic
E36 (92-99) > 328is
E36 (92-99) > M3 (1995)
E36 (92-99) > M3 (96-99)
Recently Viewed Products