Epic Custom OBD1 Chip Tuning - E36 M3 S50/S52 with Cams/HFM/injectors

Advanced calibrated tuning for a built OBD1 S52

+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -

  •   
      
      
  •  

Price:
$499.99

Building an S50 or S52 with HFM, injectors, and cams and looking for a proven, reputable, and reliable tuning solution? Epic Motorsports is our favorite tuner for the E36 engine family and someone we turn to for our own E36 race and project cars. This is a calibration file based on the popular S52 upgrades we have seen and then tweaked for your specific setup. This isn't a true “custom” tune - which requires live tuning on the dyno - but is as close to custom as we can get. Epic has been beating the competition on and off the track for 20 years.

For this chip you will need:

Euro or 540 HFM 
24lb injectors (24lb measured at 3.0 bar) 
Upgraded cams (Stock, Schrick, Epic Race, or Sunbelt) 
Headers and exhaust 
Lightweight or single-mass flywheel (small bump in idle)

Make sure you tell us any other changes in engine spec so we can double-check the calibration.

Select which Bosch ECU you are using: the early Bosch Red Label 413 (non-EWS) or the later Bosch Silver Label (413 or 506) with EWS. The Silver Label includes the EWS-delete option.

93 is the default octane. Contact us if you have other needs.

Programmed and shipped by BimmerWorld.

Notice of Emissions Non-Compliance. This software was developed and tuned on vehicles that retained all emissions controls. It is intended for vehicles with stock and fully functional emissions equipment. However, it has not been submitted nor tested for approval in California. Therefore, it is not legal for installation or use in California on any pollution-controlled motor vehicle. Not legal for installation or use on any pollution controlled motor vehicle in any state, province, or jurisdiction governed by, or which has adopted, CARB or EPA regulations.


Recently Viewed Products