Vargas Silicone Turbo Inlet Pipes - E9X 335i N54 07-10

On the stock N54 intake, air from the air filters runs into each turbo through two plastic tubes. Because of the tight fit of the E90/E92/E93 chassis these tubes are made of plastic and are crushed and molded around the various components. This hurts flow and the plastic does not hold up well to heat and chemical exposure.

BMW should have used silicone! These silicone hoses are both stronger and better flowing than the original plastic and they fit in the exact same locations as original. Made from multi-layered silicone they also hold up better with increased boost and underhood temperatures.

If you're building the a high-output turbo N54 and want reliability to match your gains, you need a set of these silicone inlets.

There are multiple variations of turbo inlets, based on your current setup:

> DV or BOV: retaining factory diverter valves (DV) or your chargepipe has been converted to a blow-off valve (BOV). The BOV version has DV ports that are plugged (keeping the option of running DVs in the future).

> Inlet ID: select from 1.75" (stock turbos) or 2.0" (upgraded turbos) inlet diameter

Emissions Notice: This product is a direct replacement for the original and closely replicates or improves on the original in fitment, form, and function. It may even correct flaws or deficiencies in the factory design. As a direct replacement upgrade it has not been designed to trick or disable any emissions controls. It is designed to work with all factory emissions controls in place. However, it has not been evaluated nor tested for emissions compliance and is not legal for installation or use in California on any pollution controlled motor vehicle or in any state, province, or jurisdiction governed by, or which has adopted, CARB regulations for aftermarket parts.

Fits 2007-2010 E90/E92/E93 335i with left-hand drive only (N54 engine).