H&R 12mm Wheel Spacers for BMW 5x112 Wheels

12mm BMW H&R wheel spacer for 5x112 BMW models with 66.5mm center bore. This is the new BMW wheel spec that all G-series BMW models use including, G01 X3, G02 X4, G05 X5, G06 X6, G07 X7, G42 2-Series, G87 M2, G20 3-series, G22 4-series, G30 5-series, G12 7-series, G80 M3, G82 M4, G29 Z4, F48 X1, and F39 X2 models.

A 12mm spacer is a special fitment on BMW G-chassis models. The stock lip may stick out further than the width of the spacer, causing the spacer to not seat all the way to the hub. You must check the existing depth of the stock lip and confirm it is less than 12mm before installing these spacers. Do not install these spacers if the lip depth exceeds 12mm. Also, the bevel on the backside of the wheel must be 90° or more. Less than 90° will not leave enough of the wheel to contact the lip.

Longer wheel bolts are absolutely required with these spacers, unless wheel studs are used.

Please measure your wheel gap before ordering spacers. Wheel spacers ARE NOT RETURNABLE if packaging is opened. Thoroughly clean the hub surface and brake rotor hat before mounting. Rust and other debris may interfere with spacer fitment. The spacer must be fully seated against the brake rotor hat (not bottomed-out on the lip). Ensure the bolt is fully engaged before use - 14x1.25 wheel bolts require 9.0 turns or 14mm of engagement to be considered fully tight. Do not use anti-seize on bolt threads and torque bolts to 88ft-lbs. Spin wheel to ensure longer wheel bolts do not interfere with hub internals.